Hello Guest it is March 28, 2024, 03:12:00 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Henco

Pages: 1
1
General Mach Discussion / Spindle control from Mach3
« on: February 25, 2018, 03:56:50 AM »
Can someone tell me how to setup and control spindle speed from mach3. My motion control card is AKZ250 and spindle control driver is BLDC motor driver HX-WS400. At the moment i am using a potentiometer to control the spindle speed it works OK but I should like to control the spindle from mach3

Pages: 1