Messages

11

General Mach Discussion / Re: ARFcnc 6040 Mach 3 USB configuration help

« on: February 15, 2018, 02:32:52 PM »

the motion card

12

General Mach Discussion / Re: ARFcnc 6040 Mach 3 USB configuration help

« on: February 15, 2018, 02:18:08 PM »

done that

13

General Mach Discussion / Re: ARFcnc 6040 Mach 3 USB configuration help

« on: February 15, 2018, 11:59:03 AM »

yes, been through that page, watched all the videos, but they do not cover how to set all the communication settings.
most videos I have seen cover the printer port setup but not to many on setting up the usb

14

General Mach Discussion / ARFcnc 6040 Mach 3 USB configuration help

« on: February 15, 2018, 11:40:16 AM »

Just purchased this on eBay. I am trying to get the configuration all set up I only have a USB port on the back of the CNC 6040 Z  control box. I can get the spindle spinning but I can't get any of the XY or Z axis to move. Does anybody have any pictures of their pin settings or what I need to do to get the USB to communicate with the machine. I feel that it is communicating a little bit because the spindle is spinning so there has to be some kind of signals going to the mach3 motion card.

Any help would be appreciated thank you