11
Mach4 General Discussion / Re: ESS not communicating to Mach 4
« on: February 12, 2018, 05:54:54 PM »
Update: I thought all was saved when I found the ribbon cable was loose, but again to no avail. The upside is that all the LEDs light up and when I use the keyboard, buttons or MDI, they light correspondingly.
Still no movement.
I am getting about 4.5v at dir and .11v at pul at my stepper drivers.
Still no movement.
I am getting about 4.5v at dir and .11v at pul at my stepper drivers.