Hello Guest it is November 19, 2019, 11:51:40 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - capdenny

Pages: 1
1
General Mach Discussion / Mach 3
« on: March 14, 2019, 03:59:58 AM »
The problem I have is when running a program my cnc will not run faster than 58 ipm, even if I manually increase the feed rate. So is there something in mach 3 that puts a limit on how fast your feed rate is? If so how do I change the limit?

Thank You
Dennis Killian AKA capdenny

2
General Mach Discussion / Probing
« on: March 17, 2018, 11:23:16 PM »
Hello,

I am a newbie and I am trying to set up a 3 axis probe. I am using a Bit Sensor breakout board. I can not get the probe work. I have tried using all the inputs and all the pins but still nothing. I can not get a picture of the board, but I do have a link that shows the board ( https://gd3.alicdn.com/imgextra/i2/1/TB1gZBOGp*********XX8Xp***************************X_!!1-item_pic.gif_400x400.jpg ).
If you could can you tell me the settings in mach3 and where on the board I connect.

Thank You,
Dennis Killian
star27@charter.net

Pages: 1