Messages

31

Mach3 and G-Rex / Re: No G100 Found

« on: August 10, 2007, 09:22:09 PM »

Thanks Brett

Got rid of the wireless net last time too and it was OK again, Was hoping the latest firmware for G100 (March) might have made it better.

Regards

Noel

32

Mach3 and G-Rex / No G100 Found

« on: August 10, 2007, 09:15:25 AM »

Hi All

I Have had the G100 runing fine until I put a wireless card in my computer. I can upload firmware and test via web browser run firmware but MacH3 will not latch onto it when I boot up. I could get rid of the the network card but again but would prefer not to. Help appreciated.
Noel

33

LazyCam (Beta) / Re: Offset not working right, V2.02

« on: July 28, 2007, 10:14:31 PM »

Hi Chip

I tried the dot idea and also using smaller cutter than the circle size and tried to cut on the inside but no go.

Noel

34

LazyCam (Beta) / Re: Offset not working right, V2.02

« on: July 28, 2007, 08:32:04 AM »

I Downloaded your fuel bracket drawing and the offset worked but the part was only about 5mm across. I used Version 2.3 . Previous versions i always found inside and outside were back to front.

Drill circles is a mystery to me as it only seems to work when it wants to. Cannot make any sense out of it. I had it working perfectlt in older versions but not now. I have sent screen shots to  Art and Brian to see  if they know why but they must be busy.

Noel