Hello Guest it is April 27, 2024, 01:16:54 AM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - wildgrav

Pages: « 1 2 3 4 »
11
General Mach Discussion / Re: Rapids in Lathe Blue Screen Set
« on: January 30, 2010, 10:21:25 PM »
Silly Me

The Font is too big for the window. gos to 999 so you cannot see 1000 in the DRO.

How do you edit that?

Noel

12
General Mach Discussion / Rapids in Lathe Blue Screen Set
« on: January 30, 2010, 07:18:52 PM »
Morning All

I have a lathe with a vertical mill on it and I have written some GCode for the moves and all goes very well except for my rapids which won't go past 600mm a minute although you can get 2m a min manually.

Anybody got any clues?

Regards

Noel

13
General Mach Discussion / Re: Version R3.042.035 No Go
« on: January 24, 2010, 01:50:25 AM »
Yep All good. Fixed it on the mill and the lathe.

Regards

Noel

14
General Mach Discussion / Re: Version R3.042.035 No Go
« on: January 22, 2010, 06:07:10 PM »
just tried to install new version on a lathe setup as well and it will not load either. System restore got it back to normal again

Noel

15
General Mach Discussion / Re: Mach XML Reader
« on: January 16, 2010, 05:32:49 PM »
Works a treat. Now there is more to learn

Well Done

Noel

16
General Mach Discussion / Re: Version R3.042.035 No Go
« on: January 08, 2010, 06:20:45 AM »
I Don't use the Shuttlepro so will give it a go tomorrow if I can stop my building leaking in this TROPICAL DOWNPOUR AHHH

Thanks Noel

17
General Mach Discussion / Version R3.042.035 No Go
« on: January 08, 2010, 04:25:47 AM »
Hi All
I installed Version R3.042.035 and it will not open. Error found ARTCODE 3092. Open the error report further and it referes to shuttpro.dll giving problems. Tried a few times and system restore got me running again. Does anyone know why the new version will not open?  ???

Regards

Noel

18
Show"N"Tell ( Your Machines) / Re: Chrisjh Home Built CNC Lathe
« on: October 10, 2009, 07:50:02 PM »
Hi Chrisjh

How did the fish tank pump go. I use a electric fuel pump from REPCO and think they cost about $90.

Regards
Noel

Townsville

19
SmoothStepper USB / Re: PWM output for spindle
« on: April 15, 2009, 05:46:59 AM »
Yep
I have a CNC4PC c23 attached to the SS

20
SmoothStepper USB / Re: PWM output for spindle
« on: April 14, 2009, 06:55:58 PM »
Got it sorted. I didn't realize that the step pin = voltage  0-10 and direction pin goes to the relay. works a treat now

Noel

Pages: « 1 2 3 4 »