1
General Mach Discussion / Santa Cruz Engineering Automatic Tool Changer Extension for MachStdMill
« on: October 03, 2020, 06:50:33 PM »
Hi All
I am running machstdmill and am trying to find info on how to setup a ATC for my 8x4 table. MSM has a page setup for the Santa Cruz Engineering
Automatic Tool Changer. There is no documentation about the hardware required in the help section and after googling my brains out I cannot even find the company. Maybe it an Australian thing!
Does anybody have this system working or any other method I could learn from.
Regards
Noel
I am running machstdmill and am trying to find info on how to setup a ATC for my 8x4 table. MSM has a page setup for the Santa Cruz Engineering
Automatic Tool Changer. There is no documentation about the hardware required in the help section and after googling my brains out I cannot even find the company. Maybe it an Australian thing!
Does anybody have this system working or any other method I could learn from.
Regards
Noel