Hello Guest it is March 29, 2024, 05:54:28 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - awleaphart

Pages: 1 2 »
1
I'm looking for a screen like the blue screen for mach3. I cant seam to find any for mach4.
Anthony l

2
Mach4 General Discussion / Re: New Screen Mach4
« on: June 17, 2018, 09:24:18 PM »
Thanks

3
Mach4 General Discussion / Re: New Screen Mach4
« on: June 17, 2018, 05:35:43 PM »
no bites. Craig where you be?
Anthony l
You must be father daying it. Happy fathers day.

4
Mach4 General Discussion / New Screen Mach4
« on: June 17, 2018, 03:50:05 PM »
Will all the screen set down loads work with Mach4 like imach and Machblue?
Anthony L

5
Mach4 General Discussion / Re: Update mach4 help
« on: June 17, 2018, 03:14:47 PM »
Got it.
Thanks alot

6
Mach4 General Discussion / Re: Update mach4 help
« on: June 17, 2018, 09:33:37 AM »
Thanks Craig,
My profile was g0704 and my screen was set to my mill. I had made a G0704 Screen but I guess somewhere down the line being a newbie it got changed to mymill. I guess all my setting was under screen my mill. I loaded the G0704 screen up but there's no setting. I pretty sure it was set to my mill. I have screen g0704 loaded now. Maybe all my setting will be saved under with Profile G0704 and Screen G0704.
  Craig,
A while back my load license file would not work. I went on the site and I some how got another one. Ii works but about once a month my Mach4 goes back to demo mode and I have to load it again. Is that normal. I have two Load Licence files. One that works and one that doesn't and both on the same PC.
Thanks Anthony L

7
Mach4 General Discussion / Update mach4 help
« on: June 16, 2018, 10:35:44 PM »
Ok,
I have updated my Mach4. Loader info came over and my controller but no setting as in pin port for controller and no motor setting. Its all blank. I saved the whole Mach4 folder before loading. Can I copy and past from there to my new updated Mach4 folder to get settings back.
Anthony l

8
Craig,
I got it to post G54. I found a video that says to put a 1 in WCS and a 2  WCS G55
Anthony

9
I have not clue. I'm new to this. But I did see it.
Anthony

10
I told it WCS G54 I did see the a P55 in the G code. I went into Fusion to make sure it was on g54 but its not changing.
Under set up-Post process-WSC Offset I have 54
Anthony

Pages: 1 2 »