1
Building or Buying a Wood routing table.. Beginnners guide.. / need help plssssss
« on: December 19, 2017, 02:37:51 PM »
Hello
I use this forum because I have no solution to my problem. i was building my cnc and I used a MACH 3 MOTION CARD MKX IV controller, the problem is that when I open a Gcode file in Mach 3 with the plugin for this card it is totally different from what I designed, if I disable the NcUsbPod plugin then mach3 open the file Gcodem I tried to change the format (tap, nc, ncc, gcm etc.,) the same result
I use this forum because I have no solution to my problem. i was building my cnc and I used a MACH 3 MOTION CARD MKX IV controller, the problem is that when I open a Gcode file in Mach 3 with the plugin for this card it is totally different from what I designed, if I disable the NcUsbPod plugin then mach3 open the file Gcodem I tried to change the format (tap, nc, ncc, gcm etc.,) the same result