Messages

21

dspMC/IP Motion Controller / Re: Error after Update to Mach4 3481 and newest dspMC Plugin

« on: November 18, 2017, 01:02:35 PM »

Yes, this unit is sitting on my bench for configuration for new machine. When I turn on the logging, I am see System Arm Error DSPMC:283.

If I disable all inputs and outputs in the machine configuration, system will stay enabled

22

dspMC/IP Motion Controller / Re: Error after Update to Mach4 3481 and newest dspMC Plugin

« on: November 18, 2017, 12:41:07 PM »

My system will not stay connected. Brand new dspMC out of the box firmware 10.10 FPGA E901 boot loader 0.06 Hardware 7762, Mach 4 3481, plugin 2.01.72
Every time I enable my system, I get system arm error and it disables.

23

dspMC/IP Motion Controller / Re: Error after Update to Mach4 3481 and newest dspMC Plugin

« on: November 18, 2017, 11:10:48 AM »

I just received an new box with firmware 10.10 FPGA E901. I change the IP address with the VSI device manager from the default .  Rescan the network and my controller is there at the new address. When I plug the controller into my network, it is assigned a DHCP address. I cannot find anything in the VSI documentation about DHCP disable.

Thanks