1
General Mach Discussion / Re: Backlash on X axis changes to A axis
« on: November 02, 2017, 07:54:54 AM »
Hi Craig,
I've been busy these days and I could not try to do the last changes until this morning. I've made the changes on the SW1 DIP switch and also modified the other switches to set them on 8 subdivisions (plus the pertinent mod to the mach3 parameters following your instructions) and now the CNC works without the problem!!! I'm very grateful for your help and explanations
Thanks a lot
Marçal
I've been busy these days and I could not try to do the last changes until this morning. I've made the changes on the SW1 DIP switch and also modified the other switches to set them on 8 subdivisions (plus the pertinent mod to the mach3 parameters following your instructions) and now the CNC works without the problem!!! I'm very grateful for your help and explanations
Thanks a lot
Marçal