Hello Guest it is September 19, 2020, 06:33:33 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Rarowe81

Pages: 1
General Mach Discussion / Re: UC100 Question
« on: October 17, 2017, 04:26:45 PM »
Thanks for the feedback. I contacted CNC Drive and am waiting to hear back from them. I'd hoped it was a common problem that had a easy solution.

General Mach Discussion / UC100 Question
« on: October 17, 2017, 12:43:41 PM »
Hello All, I'm using a UC100 on a older laptop everything is working fine until I try and hook up an external monitor. The uc100 stops communicating as soon as its plugged to the port. I don't know if there is a conflict because the uc100 is emulating com 1 and if it can be changed in Mach 3? Any help would be appreciated.

Pages: 1