Hello Guest it is March 28, 2024, 09:31:03 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - AndreiD

Pages: 1
1
General Mach Discussion / Re: Mach3 motor outputs issue
« on: February 20, 2018, 05:36:50 AM »
Tweakie thank you for reply, but after few install/uninstall of Mach3 , things return to normal.  I do not now where was the problem anyway.

2
General Mach Discussion / Mach3 motor outputs issue
« on: February 06, 2018, 03:33:16 AM »
Hello and please help.
  I have built a cnc plasma, it woks fine for a while with Mach3 trial. After I bought a license I installed Mach3 on a new Windows xp installation.  Now something  very strange is happening. My out pin assignment is like this ( for x 3-step 2-dir, y 5-step 4-dir,z 7-step 6--dir,  9-Output#1), but when I make a manual command on z azix ,Output1 activate, when I command x axis, z axis is moving instead, only Y axis is working fine.  I have change the PC and also interface board, but the result is the same. Inputs are functioning good. The machine is behave like this in any out pins configuration.

3
Thanks Craig, I did not pay attention to folders. Problem solved.

4
Hi,  I have a macro to zero z axis with floating head for my plasma table using G31 and probe imput. The macro is working fine from VB editor but I cannot trigger it from MDI or Gcode, it simply does nothing. I tried also with other simple macros, but none can be trigger. Default macros are working fine from MDI and also Gcode. Please help.

Thank You,

Pages: 1