Guest
Show Posts
101
General Mach Discussion / Getting 2nd port to show its pins on diagnostics page...
« on: October 12, 2017, 02:40:12 AM »
Hi,
I have added a 2nd port card for running a 4th axis lathe, but cant get the 2nd port to show up on the diagnostics pages, so I can figure out the setup. Can anyone give me the procedure to cause the 2nd port to show up so I can see all 48 pins etc..
Thanks Halfmill
I have added a 2nd port card for running a 4th axis lathe, but cant get the 2nd port to show up on the diagnostics pages, so I can figure out the setup. Can anyone give me the procedure to cause the 2nd port to show up so I can see all 48 pins etc..
Thanks Halfmill