Hello Guest it is September 22, 2019, 12:40:00 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Attachments - halfmill

Pages: « 1 2
Filename Downloads Message Posted
curve with end mill.jpg 257 Re: A-axis rotary lathe question for Mach 3 November 04, 2017, 01:17:57 PM
curve with 90 degree wall.jpg 243 Re: A-axis rotary lathe question for Mach 3 November 04, 2017, 01:17:57 PM
Basic setup.jpg 254 Re: A-axis rotary lathe question for Mach 3 November 04, 2017, 01:17:57 PM
Bobs guitar head.JPG 171 Re: A-axis rotary lathe question for Mach 3 November 04, 2017, 03:29:28 AM
bob guitar front.JPG 208 Re: A-axis rotary lathe question for Mach 3 November 04, 2017, 03:28:50 AM
guitar bridge example.JPG 213 Re: A-axis rotary lathe question for Mach 3 November 04, 2017, 03:27:06 AM
bobmill.xml 108 Re: A-axis rotary lathe question for Mach 3 November 03, 2017, 02:55:49 PM
Pages: « 1 2