Hi,
Just got a little bit lost with this G-Code I generated using from an Eagle design using PCB-Gcode, When running the code as in attachment,Commands "R0.1000 cause an error "R Less thanY in XZ Plane" this is in line 47.
G82 X-0.8000 Y2.4000 Z-0.0320 F20 R0.1000 P1.000000
Also what is the P1.00000
, "P Serves as parameter address for various G and M codes
With G04, defines dwell time value.
Also serves as a parameter in some canned cycles, representing dwell times or other variables.
Also used in the calling and termination of subprograms. (With M98, it specifies which subprogram to call; with M99, it specifies which block number of the main program to return to.)"
Can I delete both these command as R seems to relate to an arc.
Also stops on the "M03" command "To fast for pulley using Max" but carries on think that may related to spindle set at "S20000" which is not running on this test and is prob way faster than my spindle, so just need to edit as required..
Regards John