Messages

11

General Mach Discussion /

« on: September 19, 2017, 01:58:14 PM »

Craig its definately win 10 pro 64bit ill check if i can post a picture for you power is just off at the moment as soon as its back up ill start everything and take photos for you and post it

Sent from my SM-G900H using Tapatalk

12

General Mach Discussion / Re: Interference with axis motors

« on: September 19, 2017, 08:08:14 AM »

Hi again craig this is the mach3 i have installed with the standard mach3 V2 software

http://www.cncdirect.co.za/htm/mach.html

13

General Mach Discussion /

« on: September 19, 2017, 07:40:59 AM »

Ill post pics when im at home that use to be my job man applications developer

Sent from my SM-G900H using Tapatalk

14

General Mach Discussion /

« on: September 19, 2017, 06:34:59 AM »

Hi craig jip its a I3 intel machine loaded with a gtx770 and 16gb ram with a PCI parallel port card installed so i can run the mach3 on it it works like a dream exept for the interferance as mentioned.

Than you so much for the help ill be at home in about 5 hours then ill try all this i hope it is a simple as that

Sent from my SM-G900H using Tapatalk

15

General Mach Discussion / Interference with axis motors

« on: September 19, 2017, 03:54:49 AM »

Sorry this should have said "Could it be a shielding problem on the wires."


Sent from my SM-G900H using Tapatalk

16

General Mach Discussion /

« on: September 19, 2017, 03:52:44 AM »

Hi Craig

It still uses the parallel port could that be a problem.

When i received the machine all the power was on one plug socket and the pc on another and the original owner said it worked fine like that... ill go tonight an change the vfd to its own power cable seperate from the pc and the bob use leads to connect the unit to different wall sockets so they are far apart from each other. 

Could it be a shieling problem on the wires.

I urgently need to get this machine working ill stip it and do all new wireing and electics in december when i do shut down.

Thanx
MAV

Sent from my SM-G900H using Tapatalk

17

General Mach Discussion / Interference with axis motors

« on: September 18, 2017, 04:12:02 PM »

Hi all i purchased a CNCMASTERS CNC JR.  Through a auction a few monthes ago the previous owner did a mach3 conversion on it but still working on the standard hardware and drives.

I have got the axis motors to work and the spindle issue is using them together. As soon as the spindel starts the axis motors goes haywire. But as soon as the spinde motor is off and the cnc jr. Is restarted the axis works fine till the spinle goes on again.

Hardware
Pc with win 10 64bit
Mach3 board and mach3mill software
Standard cnc jr. Motors and drivers
Speedmaster sm vfd
 
Kind regards
MAV

Sent from my SM-G900H using Tapatalk