Messages

71

General Mach Discussion / Re: Can not seem to carve out a simple box ?

« on: September 27, 2017, 12:16:08 PM »

Now...example...x-axis instead of reading +8.00 for and 8" plate at the 8" mark...Now reads +200 at 8 inches.....SMH

72

General Mach Discussion / Re: Can not seem to carve out a simple box ?

« on: September 27, 2017, 11:36:39 AM »

OK...I am Engraving...Cut out the Box...Ran some test plates...All Good...Shut down, Come Back....Now...Its like it wants to engrave on something the size of a pin head...I just don't get it

73

General Mach Discussion / Re: Can not seem to carve out a simple box ?

« on: September 27, 2017, 08:13:32 AM »

Thank you...Different Animal than the Dahlgren

74

General Mach Discussion / Re: Can not seem to carve out a simple box ?

« on: September 27, 2017, 07:22:37 AM »

55....

75

General Mach Discussion / Re: Can not seem to carve out a simple box ?

« on: September 27, 2017, 06:49:51 AM »

Figured it out.......Had to re-set the Motor Tuning....So what we have to do...for now....Since this will be used for multiple runs...Set in Engravelab (We have 5.0 on a Windows 98 machine)...Export as dxf....Bring into this one and...VIOLA ! ! !
Hopefully I will have no more questions and my hair will grow back from where I had pulled it out

76

General Mach Discussion / Re: Can not seem to carve out a simple box ?

« on: September 26, 2017, 02:36:11 PM »

Got Tired, Brought it over to Engravelab Machine...Export as dxf...Cuts Fill but stops about 1/2 thru a 2x8 name plate
ALEX MARTINEZ.....Cuts as ALEX I

77

General Mach Discussion / Re: Can not seem to carve out a simple box ?

« on: September 26, 2017, 11:34:34 AM »

Its Not There...No Link to Download

78

General Mach Discussion / Re: Can not seem to carve out a simple box ?

« on: September 26, 2017, 11:30:18 AM »

Thanks...We just do Basic Engraving.. Nameplates  Seals & Plaques

79

General Mach Discussion / Can not seem to carve out a simple box ?

« on: September 26, 2017, 11:10:10 AM »

Hi, I am trying to make a simple cut out in wood.....4x12 that i will use as a template....I have use the V-Carve Option, the Inlet Option. When I save its as a DXF...Convert in Lazycam to a Tap...Bring in Mach 3.....All I get is an "Empty" box with nothing in the middle to carve out..

Getting frustrated
Billy

80

General Mach Discussion / Re: Cutting / Engraving only the Fill ?

« on: September 25, 2017, 09:11:24 AM »

Thank you ! ! ! ! !....Maybe I have been using the wrong terminology in my searches as well