Messages

21

Share Your GCode / Re: Hows That Beer Flight Looking

« on: September 29, 2017, 05:36:56 PM »

Tweakie I think there's something wrong with that code as well.
If not it's at my end
I'm having some lash problems on my Y
Rails

22

Share Your GCode / Re: Hows That Beer Flight Looking

« on: September 29, 2017, 11:34:40 AM »

Thanks

23

Share Your GCode / Re: Hows That Beer Flight Looking

« on: September 29, 2017, 11:08:17 AM »

The largest endmill I have is 3/8"
But the shape was way off plus the holes were not round

24

Share Your GCode / Re: Hows That Beer Flight Looking

« on: September 29, 2017, 11:03:51 AM »

Hi ,
Did you try to run that code on a machine?
It was not cutting the shapes correct
It was way out.
I'm guessing it could be at my end

Thanks for your Intrerest

25

Share Your GCode / Re: Hows That Beer Flight Looking

« on: September 28, 2017, 01:23:10 PM »

1" material- 16" long. 5" wide
3 holes (pockets) 2.75"
1/2" deep

The holes need to be far enough away that there's Aprox 1.5" clearance for the beer

26

Share Your GCode / Hows That Beer Flight Looking

« on: September 27, 2017, 05:24:29 PM »

Hey all,
New guy here.
Im looking for a G code for a beer flight.

Just something simple to get me started.

Thanks

Danny

27

General Mach Discussion / Re: Router wont move

« on: September 26, 2017, 08:25:22 AM »

Thanks
It was the printer cable
Working now

28

General Mach Discussion / Re: Router wont move

« on: September 25, 2017, 06:26:54 PM »

I ran the driver test and its good.

For some reason I think its somthing to do with the parrelel ports
When i hit update drivers the gantry made a bump noise
sounded like it wanted to go
but still no movement after 10 hrs working on it

29

General Mach Discussion / Router wont move

« on: September 25, 2017, 04:03:02 PM »

I reinstalled mach3 with the lic. and deleted the old user files (maybe still in the recycle bin)

I should have wrot the old pin numbers down but i dident.
I got the pin numbers from the industrial site.

What my problem is I cant get the router to move at all
On the keyboard it shows in the DRO screen that x - Y AND z are moveing withe the proper keys on the keyboard
Jogging tab is On
Im not sure where to look next
The router table is running with the E stop out but No signal to the Gantry
I rebboted still nothing in jog

Any Tips guys?

Thanks

Danny

30

General Mach Discussion / Do I need to Delete old users file

« on: September 24, 2017, 02:49:03 PM »

Hi all,

I have a used cnc router, and it had the trial mach3 on the computer that it came with

I bought the mach3 license and tried to install it as instructed
And it wont load.
I do see the old users name up in the address bar

Do I need to delete the whole old trial Mach3 and install a new trial and then install my new license?


Thanks for your input

Danny