Messages

31

Mach4 General Discussion / Re: G code to change rapid speeds

« on: December 15, 2021, 06:33:10 AM »

OK thanks!
I'll try tomorrow!

32

Mach4 General Discussion / G code to change rapid speeds

« on: December 15, 2021, 04:19:03 AM »

I have a third-party controller on which it is possible to change rapid speeds, I find it very convenient, if possible I would like to use a similar function with Mach4 too, is it possible?
I give example:
G103 V3000
the value of 3000 will be expressed in mm / min (I am European) and will be the maximum threshold.
being a G code it is modal.
to bring the axis speed back to the maximum it will be sufficient to write
G103 V0
thanks for any information.

33

Mach4 General Discussion / Re: Mach3 script conversion into macros for Mach4

« on: October 04, 2021, 01:54:51 AM »

hello I have already posted
view attachments of the first post of the post.
I love Mach4, I use it with great satisfaction on the lathe.
I built a new machine and wanted to use the Mill version.
or are there already solutions that I don't know?
I want to do part zero through a master instrument.
each subsequent tool must refer to the master through a previously stored value.
the new tool will update the part zero based on the new length.

34

Mach4 General Discussion / Re: Mach3 script conversion into macros for Mach4

« on: September 30, 2021, 04:12:37 PM »

I have already pointed out that I am unable to do this.
patience does not matter, it will mean that I stay at Mach3.
thanks anyway.

35

Mach4 General Discussion / Re: Mach3 script conversion into macros for Mach4

« on: September 30, 2021, 06:38:59 AM »

I try to formulate the question differently ..
in MTC mode is it possible to have a master tool as an initial reference?
so that each subsequent tool references the first tool by updating the part zero?

36

Mach4 General Discussion / Re: Mach3 script conversion into macros for Mach4

« on: September 30, 2021, 04:27:45 AM »

Again, I don't know anything about programming!
i am european, i like the sport of football.
Although I am aware that I will never be a footballer.

37

Mach4 General Discussion / Re: Mach3 script conversion into macros for Mach4

« on: September 30, 2021, 03:55:38 AM »

I thank you for your advice, unfortunately I am not able, I work metal, I am not a programmer.

38

Mach4 General Discussion / Mach3 script conversion into macros for Mach4

« on: September 29, 2021, 06:01:22 PM »

as the title suggests I would need to convert these scrips into macros for Mach4.
it is possible to do?
thanks in advance for help!

39

Mach4 General Discussion / Re: External button scripts in Mach4

« on: September 29, 2021, 05:52:48 PM »

these functions are of great interest to me too!
were you able to recall MDI via button?

40

Mach4 General Discussion / Re: Connection Lost with CSMIO/IP-S

« on: May 26, 2021, 05:19:38 AM »

have you tried with SimCNC?
if you have the same problem then CSMIO is to be sent for repair.