Messages

211

Mach4 General Discussion / Re: Add or edit Mach4 Lathe screen

« on: November 14, 2018, 03:52:44 PM »

YESSSS !! It works!!
I inserted script in the wrong page !!
now it's in the right place, it's all OK!
the translator helps a lot, but there is always a bit of difficulty in understanding well.
Thank you so much!!

212

Mach4 General Discussion / Re: Add or edit Mach4 Lathe screen

« on: November 14, 2018, 10:34:20 AM »

Hi,
Yes sure
I attach image.

213

Mach4 General Discussion / Re: Add or edit Mach4 Lathe screen

« on: November 12, 2018, 12:32:31 PM »

Hi,
It's not a problem, I'm not in a hurry.
the error report was referred to this:

--Featured added 11-9-18
--Set RRO to 25% on start up
if testcount == 1 then
    mc.mcCntlSetRRO(inst, 25)
end

214

Mach4 General Discussion / Re: Add or edit Mach4 Lathe screen

« on: November 10, 2018, 03:25:57 PM »

Hi,
I report this error.
unexpected symbol near 'if'


acoustic signal instructions where should I enter?
if I put it in PLC it will only sound when I open Mach4.

215

Mach4 General Discussion / Re: Assign input to the controller, CICLE START button

« on: November 09, 2018, 04:07:49 AM »

Note:
with the second code, it did not work for me.
I'm using the first one.
Mach4 boot active part, but it is not a problem.

216

Mach4 General Discussion / Add or edit Mach4 Lathe screen

« on: November 09, 2018, 04:04:03 AM »

Hi everyone

Is it possible to add a sound to the "Change tool" LED?
A simple "beep" at every impulse would be excellent.

Mach4 starts with a 100% slide Rapid Rate
Is it possible to change this condition and start with 25%?

217

Mach4 General Discussion / Re: Assign input to the controller, CICLE START button

« on: November 09, 2018, 01:35:15 AM »

Yes,Yes!
Very good!
thank you again!

P.S. I would like to add some sounds to Mach4, but I open a dedicated topic.

218

Mach4 General Discussion / Re: Assign input to the controller, CICLE START button

« on: November 08, 2018, 05:54:56 AM »

Hi,
toggles correctly.
thanks you have been very kind!!

219

Mach4 General Discussion / Re: Assign input to the controller, CICLE START button

« on: November 07, 2018, 05:09:56 PM »

Hi,
Yes, it works
part immediately active.
can you do it reverse?

220

Mach4 General Discussion / Assign input to the controller, CICLE START button

« on: November 07, 2018, 01:57:22 AM »

Hello to the whole forum.
I'm italian, I use google translate.
I would like to assign an external key to the SINGLE BLOCK function, then an Input for the controller.
how can I do?
I own CSMIO-IP / S
thank you.