11
Mach4 General Discussion / Re: Auto Tool Setter Offsets
« on: December 01, 2022, 02:38:55 AM »
sorry, but in my opinion there really is a tool change management problem.
the only really correct procedure is to measure the height of the hollow spindle nose (as zero tool).
then subsequently based on each tool that will be mounted, Mach4 will have to make a difference in height, using the G43 H....
I use this system on the Rosetta controller. https://www.youtube.com/watch?v=agODOhWnJjs&t=449s
It works perfectly! I would like to do the same thing with Mach4!
the only really correct procedure is to measure the height of the hollow spindle nose (as zero tool).
then subsequently based on each tool that will be mounted, Mach4 will have to make a difference in height, using the G43 H....
I use this system on the Rosetta controller. https://www.youtube.com/watch?v=agODOhWnJjs&t=449s
It works perfectly! I would like to do the same thing with Mach4!