Hello Guest it is February 26, 2024, 05:53:23 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - RoyalMachine

Pages: 1
1
VB and the development of wizards / Re: VB For THC Up / THC Down
« on: August 23, 2017, 11:29:33 AM »
I need two macros. One that activates THC Up, and one that activates THC Down.

I've not really done much VB Scripting and from all the Mach3 scripting commands I see I can't determine how I would get a macro to do this. I see other THC controls, but not for THC Up and THC Down. Is it possible? Could someone point me in the right direction? Thanks!

I have THC Up and Down set to F8 and F7, so each macro needs to activate those keys. Going to assign the macro to Xbox controller buttons.

2
VB and the development of wizards / VB For THC Up / THC Down
« on: August 23, 2017, 11:01:00 AM »
I need two macros. One that activates THC Up, and one that activates THC Down.

I've not really done much VB Scripting and from all the Mach3 scripting commands I see I can't determine how I would get a macro to do this. I see other THC controls, but not for THC Up and THC Down. Is it possible? Could someone point me in the right direction? Thanks!

3
Mach SDK plugin questions and answers. / Re: X Box problems
« on: August 18, 2017, 11:18:19 AM »
EDIT: Old topic. Nevermind.

4
General Mach Discussion / Xbox Controller & THC Up, THC Down
« on: August 18, 2017, 11:00:31 AM »
Hello,

I'm using an xbox 360 controller with Mach3 for my plasma/oxyfuel cutting table and there are a few buttons I'm not sure how to assign. I'm using F8 and F7 to control THC Up and THC Down while using a keyboard (so I can manually control the height while cutting). I can't find any obvious way of assigning these actions to a couple buttons on the controller.

I'm not sure if I need to use a macro or what but I was hoping someone would have an answer for how to do this.

EDIT: I may have put this in the wrong forum. Not sure if I'll end up needing a macro or whether it's something easy with the plugin but I imagine either the Plugin forum or the VB forum would have been more appropriate. My apologies.

Pages: 1