Hello Guest it is March 28, 2024, 07:41:11 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - wegy

Pages: 1
1
Hello My friends,

Please i need your support ,its my new CNC machine and i need to use the following electronic system to run The machine:

Arduino 2560
TB6560 4 Axis 3.5A Stepper Driver Board Controller
Mach4 Controller

All i need the wiring diagram Between Arduino 2560 + TB6560 4 Axis 3.5A Stepper Driver Board Controller,
and configure these components in Mach4

to control (if i need ) 6 Axis via Mach4 using USB cable via Arduino 2560
i see some topics about modbus protocol,but i wish clear and easy step (step by step with supported codes if any) to do this project please

Thank you in advanced

Regards

Pages: 1