1
Mach4 General Discussion / Modbus Programming guidance needed
« on: November 23, 2020, 11:51:01 AM »
I am in need of information about programming the MODBUS. I am unable to find documentation or examples that would allow me to setup a separate DRO on the machine that is connected to my MACH 4 computer via MODBUS. The scripting manual ends at section 5.7 called MODBUS with no detail. I have found some info but most is in German and I don't speak German.
I just want to update a Write parameter on the MODBUS DRO display whenever the XYZ and RPM values change on the MACH 4 screen.
If anyone could point me in the right direction, it would be very much appreciated.
Bob
I just want to update a Write parameter on the MODBUS DRO display whenever the XYZ and RPM values change on the MACH 4 screen.
If anyone could point me in the right direction, it would be very much appreciated.
Bob