1
General Mach Discussion / Mach3 Mill and CNC JR
« on: July 10, 2007, 06:18:45 PM »
I have a older CNC JR that runs on DOS and has an AC Tech motor control.
The Driver boards have been back to the factory twice and still don't work correctly.
I am interested in replacing the driver boards and running Mach3 Mill.
Possibly Gecko G100. Can anyone offer any suggestions of other driver boards. I
watched some Mach3 videos and they were down loading firmware to flash the controls.
Where I am working there will not be Internet access.
Thanks for you time.
Leslie A. Bright
The Driver boards have been back to the factory twice and still don't work correctly.
I am interested in replacing the driver boards and running Mach3 Mill.
Possibly Gecko G100. Can anyone offer any suggestions of other driver boards. I
watched some Mach3 videos and they were down loading firmware to flash the controls.
Where I am working there will not be Internet access.
Thanks for you time.
Leslie A. Bright