21
General Mach Discussion / Auto Z zero
« on: October 02, 2018, 12:49:20 PM »
Hi all,
I had a computer crash some weeks ago, when my power supply in to computer went dead.
I have manage to reinstall my Mach3 to almost where this happened,( I am using screen set 2010 and have been very happy with it from the start), all but the auto Z for when I do a tool change.
When I click ether button on the tool bar I get the following message. CLEARANCE PLANE MUST > 0 - PLEASE RESET.
Can anyone throw some light on this.
Mike
I had a computer crash some weeks ago, when my power supply in to computer went dead.
I have manage to reinstall my Mach3 to almost where this happened,( I am using screen set 2010 and have been very happy with it from the start), all but the auto Z for when I do a tool change.
When I click ether button on the tool bar I get the following message. CLEARANCE PLANE MUST > 0 - PLEASE RESET.
Can anyone throw some light on this.
Mike