Messages

21

PoKeys / Re: Pokeys57cnc 10v spindle control only reaches 8.1v

« on: May 25, 2017, 11:21:48 AM »

I'am sure that i can turn the pot without any problems. I've bought a special small screwdriver for it. In Mach3 it works without any problems.

22

PoKeys / Re: Pokeys motion steps overflow [solved]

« on: May 20, 2017, 11:07:12 AM »

Hi NeoTO,

,thankyou the problem has been solved with the last pokeys plugin update. TOP!

23

PoKeys / Re: Pokeys57cnc 10v spindle control only reaches 8.1v

« on: May 19, 2017, 09:22:44 AM »

I power it directly with a 24V wall plug.
regards

24

PoKeys / Re: Pokeys57cnc 10v spindle control only reaches 8.1v

« on: May 18, 2017, 08:53:34 AM »

I've the same problem. I could set the rpm in mach4 "spindle" "min and max rpm" to adjust the outputvoltagespektrum of the pokeys57cnc. The rpm area isn't as big as needed.  I can start from 9000 to 22000. i've used the pot too. regards
www.cncprint.blogspot.com

25

PoKeys / Re: Pokeys motion steps overflow

« on: May 18, 2017, 08:45:32 AM »

hi,

i had the same problem. you are not allowed in pokeys57cnc to drive more than one axis simultaneously in JOG mode.
regards
www.cncprint.blogspot.com