1
General Mach Discussion / Re: E-Stop interrupt without reason
« on: May 08, 2017, 04:39:54 AM »
Thanks Tweakie
As i wrote before, there is no external or internal trigger on the inputs to see in the diagnostics.
It happens not each time but sometimes its a big issue. Actually it runs well again.
Tooks me nearly 1 hour to get it running again, appears at automatic-run, manual-jog and still at reference-drive.
I still tried to switchoff the watchdog of mach3 and the E-stop i set to LPT2 without any function. Still a deactvating of all input-pins wont change this issue.
AC-Filter is inside both controllers.
For me absolutly strange how the same issue happens on two different systems, machines and controllers.
Electrical noise could be a reason here in China ^^
As i wrote before, there is no external or internal trigger on the inputs to see in the diagnostics.
It happens not each time but sometimes its a big issue. Actually it runs well again.
Tooks me nearly 1 hour to get it running again, appears at automatic-run, manual-jog and still at reference-drive.
I still tried to switchoff the watchdog of mach3 and the E-stop i set to LPT2 without any function. Still a deactvating of all input-pins wont change this issue.
AC-Filter is inside both controllers.
For me absolutly strange how the same issue happens on two different systems, machines and controllers.
Electrical noise could be a reason here in China ^^