Guest
Show Posts
1
General Mach Discussion / Waterjet Diagonal lines
« on: March 29, 2017, 06:03:07 AM »
Hi All,
Recently i encountered a problem when cutting diagonal lines.
First i tried to look if there were any hardware problems, some bearings were a little loose but nothing serious.
My second step was looking if the problem still occurred when using the axis separately.
This resulted in clean cuts.
The wavy pattern can be traced back to the tool path. Here you can see the "point" dance around the actual cutting line.
Does somebody have any idea how to solve this?
Thanks in advance,
Jim
Recently i encountered a problem when cutting diagonal lines.
First i tried to look if there were any hardware problems, some bearings were a little loose but nothing serious.
My second step was looking if the problem still occurred when using the axis separately.
This resulted in clean cuts.
The wavy pattern can be traced back to the tool path. Here you can see the "point" dance around the actual cutting line.
Does somebody have any idea how to solve this?
Thanks in advance,
Jim