Guest
Show Posts
1
General Mach Discussion / Newbie here, be gentle with me!! :-) JOG Issues ?
« on: March 27, 2017, 10:57:29 AM »
This is a new build machine for Wood routing. Running Windows 7.
Samsung i7 with 8 gig of ram laptop using USB control board.
I've went through and set up the software settings and configs to the best of my knowledge. But it seems that isn't much.
Problem is X and Z axis are reversed,, but I can change that by swapping the wires on Breakout board.
When looking at the Jog Screen the X+ Y+ and Z+ are Green and not responding.
The X- Y- and Z- are Red and do jog the machine.
Thank you for your insight and expertise.
cubs
Samsung i7 with 8 gig of ram laptop using USB control board.
I've went through and set up the software settings and configs to the best of my knowledge. But it seems that isn't much.
Problem is X and Z axis are reversed,, but I can change that by swapping the wires on Breakout board.
When looking at the Jog Screen the X+ Y+ and Z+ are Green and not responding.
The X- Y- and Z- are Red and do jog the machine.
Thank you for your insight and expertise.
cubs