1
General Mach Discussion / Re: Help with signals/motors for "Blacktooth" laser cutter
« on: March 08, 2017, 02:44:28 PM »
Tweakie,
Thanks again for the quick responses. I have uploaded a photo of the breakout board to the folder, sorry for the low resolution. I have checked on the pins and as far as I can tell it is wired correctly. I have read the article that you sent me and I am making sure all my values are correct. As for the drivers I'm not really sure because the laser cutter was built originally 3 years ago. I will let you know if I make any progress. Thank you for the help.
Robert.
Thanks again for the quick responses. I have uploaded a photo of the breakout board to the folder, sorry for the low resolution. I have checked on the pins and as far as I can tell it is wired correctly. I have read the article that you sent me and I am making sure all my values are correct. As for the drivers I'm not really sure because the laser cutter was built originally 3 years ago. I will let you know if I make any progress. Thank you for the help.
Robert.