Hello Guest it is March 29, 2024, 07:18:02 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - greek95243

Pages: 1
1
It does this even with Machs sample codes and sometimes says out of data

2
General Mach Discussion / z axis wont move up but will move down
« on: March 06, 2017, 05:12:46 PM »
this just happened don't know what happened

3
General Mach Discussion / Re: Machine stops at line 496
« on: March 06, 2017, 04:53:11 PM »
will move down not up

4
General Mach Discussion / Re: Machine stops at line 496
« on: March 06, 2017, 04:52:31 PM »
I wish I could buy you a drink you are super smart thanks again    but one more thing now my z axis wont move up by jogging

5
General Mach Discussion / Re: Machine stops at line 496
« on: March 06, 2017, 04:46:20 PM »
thank you and God Bless

6
General Mach Discussion / Re: Machine stops at line 496
« on: March 06, 2017, 04:37:45 PM »
yes I do

7
General Mach Discussion / Re: Machine stops at line 496
« on: March 06, 2017, 03:55:07 PM »
I guess I'm too stupid to live I'm not sure how to do that

8
General Mach Discussion / Re: Machine stops at line 496
« on: March 06, 2017, 03:30:39 PM »
I unzipped it and that's about it tried to open the file dat but was just told I couldn't open that

9
General Mach Discussion / Re: Machine stops at line 496
« on: March 06, 2017, 03:28:49 PM »
I bought it from Automations tech and I cant figure out how to get to the license part to use it.I am not computer savy

10
General Mach Discussion / Machine stops at line 496
« on: March 06, 2017, 09:44:42 AM »
I thought it was gcode from photo carve so I tried one of the sample codes but still the same cleaned my discs thinking its a memory problem but still doing the same thing any ideas?

Pages: 1