Hello Guest it is September 30, 2023, 09:27:02 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - matthew86

Pages: 1
Hi guys
I need help please, im going round in circles.

I have recently built a 1500 x 1000 v slot belt driven 3 axis machine.
I have used the setup function to set the steps and when I tell the axis to move 10mm it does, so I enter that value. it matches on the dro too.

now when I load code to run programme I want to machine a rectangle of 30mm x 10mm and when its machined it both dimensions are off by .5mm

what am I doing wrong?

I am using nema 23 stepper motors 1.8 and I am getting lost

any help would be fantastic

Pages: 1