Messages

1

General Mach Discussion / Re: Drivers

« on: March 07, 2018, 01:48:09 AM »

Thanks

2

General Mach Discussion / Drivers

« on: March 05, 2018, 11:19:08 AM »

During the operation these words were written"driver watchdog" in mach3.what is this?thanks

3

General Mach Discussion / Calibration change

« on: April 09, 2017, 03:57:26 AM »

Hi,during the operation the machine cordinates change and it cuts wrongly,l checked that the calibration on Y axe changed.What is the problem?

Any suggestion??

4

General Mach Discussion / Re: too fast for pulleys...using max

« on: April 07, 2017, 07:19:13 AM »

Thanks

5

General Mach Discussion / change the coordinates

« on: April 07, 2017, 12:04:34 AM »

Hi,during the operations machine begins to change the cutting place and stops because of machine limit how  can l solve this problem,thanks

6

General Mach Discussion / Re: too fast for pulleys...using max

« on: April 06, 2017, 11:54:43 PM »

Thank you so much,but l am not using spindle automatically l use cutting machine and its rpm is 33000.l think l must deactive the spindle in config.is it ok?

7

General Mach Discussion / too fast for pulleys...using max

« on: April 06, 2017, 02:45:11 AM »

Hi,during the operations these words are flashing "too fast for pulleys...using max"
how can l solve this issue?thanks

8

General Mach Discussion / switches

« on: March 26, 2017, 07:32:57 AM »

Hi,tell me please can l use one switch for homing and limiting at the same time?
thanks

9

General Mach Discussion / motors tuning

« on: February 13, 2017, 03:12:44 AM »

HI,l want to use SFU1604-3 model ballscrew with nema 34HS9840 motors.Please tell me steps per,velocity and acceleration.unit is mm.thanks

10

General Mach Discussion / About the motors

« on: February 05, 2017, 01:51:49 AM »

HI,l use 34hs9840 model motor.l want to know the maximum and minimum velocity per mm in motor calibration,l use mach 3.thanks