Hello Guest it is March 28, 2024, 06:00:16 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - spindextools

Pages: « 1 2
11
General Mach Discussion / Mach 3 not Moving in any axis!! HELP PLEASE!!
« on: January 17, 2017, 05:42:22 AM »
Hi, I'm new to this.. We use Mach 3 in our workshop to run our little CNC router. Since Christmas, it's not been talking to the cnc for some reason? We are running Mach 3 on Windows 7. The program is talking to the box, the lights all work.. If you manually push the end switch on each axis, the light goes out, as usual. The problem is there seems to be something stopping the power into each axis. It just wont run the program. I noticed when I switched off the power, they moved slightly... where can I go to get an answer? I've attached some pictures to help... Thanks!!

12
Hi, I'm new to this.. We use Mach 3 in our workshop to run our little CNC router. Since Christmas, it's not been talking to the cnc for some reason? where can I go to get an answer? Thanks!!

Pages: « 1 2