Hello Guest it is May 26, 2024, 09:16:14 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Firechief

Pages: 1 2 3 »
1
Mach4 General Discussion / Re: Windows 10 Closing Mach4
« on: February 22, 2018, 10:12:19 AM »
Good idea... I will check tonight on that.
THANKS

2
Mach4 General Discussion / Windows 10 Closing Mach4
« on: February 22, 2018, 10:03:44 AM »
I have mach4 run on a windows 10 controlling a CNC Router. when I running gcode mach4 will shut down in the middle of a cut. It is just like you clicked the X up in the corner. No errors given, I can click on the mach icon on the desktop and start it back up. Everything working with no errors,  then I run some code and it will close the program again never the same time 1 min maybe 5 min in. Windows is doing this I think. Any help would be great, scraping parts is not fun.  

3
Mach4 General Discussion / Following top of sheet with Z
« on: January 14, 2018, 12:36:00 PM »
Can there be a way of following top of your sheet? I have to cut a 1/16ā€ slot .080 deep in a flat sheet of PVC 4ā€™ X 5ā€™. With turn and lines. The sheet has a change of .003 to .006 in thickness. I need to try and hold .080 as close as I can.

Just a long shot

4
Mach4 General Discussion / Re: Z 0 help
« on: January 14, 2018, 12:14:10 PM »
Does the type of wire that leads to the touch off plate make any difference? Should I you a shielded wire as well
Thanks everyone for all the help on this.

5
Mach4 General Discussion / Re: Z 0 help
« on: January 13, 2018, 09:51:16 PM »
So I will need to put a 10k in line at the bob. This will go between the bob and the probe wire?

6
Mach4 General Discussion / Re: Z 0 help
« on: January 13, 2018, 10:31:30 AM »
Mach4 build that I have is 3481. The only time it will do this is when the tool touches the plate. Not sure about loading?? How do I load it?


7
Mach4 General Discussion / Re: Tool Finding
« on: January 12, 2018, 11:18:42 PM »
Thank for the help...
I got this to work

8
Mach4 General Discussion / Z 0 help
« on: January 12, 2018, 11:16:43 PM »
Iā€™m using mach4 and pmdx 424 board. When I probe down with a G31 to touch the set plate, when it touch the plate it will jump maybe .010. Not sure way this is happening. It does not do it all the time 1 out of 3 times. It will continue with the rest of the routine but the dro in mach4 will be off.
Any help would be great.

9
Mach4 Videos / Re: Creating an M6 Toolchange in Mach4 (Part 3)
« on: January 12, 2018, 10:46:59 AM »
I will be looking forward to the new video. I have your tool change run at this time.
Thanks.

10
Mach4 General Discussion / Re: Lua editor
« on: January 10, 2018, 09:15:09 AM »
That worked... Thanks for all the help.
Firechief

Pages: 1 2 3 »