1
General Mach Discussion / Slow multiaxis feed
« on: December 04, 2016, 02:18:51 PM »
Hi
The problem is that machine won't reach to g-code feeds. Every time when tool-path changes direction machine slows down. Is there any way to cancel such behavior or is this controller based issue?
Controller is some sort E-Cut controller, pic: http://imgur.com/a/8P88H
Video of described behavior: https://youtu.be/0NyqkZ0JZpk
Haas has g187 smoothness parameter is there any chance that Mach 3 could have same kind setting?
Best Reagards!
MicroSD
The problem is that machine won't reach to g-code feeds. Every time when tool-path changes direction machine slows down. Is there any way to cancel such behavior or is this controller based issue?
Controller is some sort E-Cut controller, pic: http://imgur.com/a/8P88H
Video of described behavior: https://youtu.be/0NyqkZ0JZpk
Haas has g187 smoothness parameter is there any chance that Mach 3 could have same kind setting?
Best Reagards!
MicroSD