1
General Mach Discussion / Re: Plasma fires on any axis move + no THC. Please help.
« on: December 14, 2016, 01:17:11 PM »
Thank you BKTeater, that worked for the THC!
The torch was still firing on any axis move but not under M3. I designated the spindle control relay to output 2 and then enabled output 2 (instead of 1) and designate pin17 (exactly like it was for output 1) and behold it works. I can't figure out why that worked...
The torch was still firing on any axis move but not under M3. I designated the spindle control relay to output 2 and then enabled output 2 (instead of 1) and designate pin17 (exactly like it was for output 1) and behold it works. I can't figure out why that worked...