Topics

1

General Mach Discussion / torch is not coming on/off automatically

« on: November 13, 2017, 07:26:45 AM »

I hate old computers .... I had to replace the hard drive and reinstalled Mach3 everything is working but the torch is not coming on/off automatically (torch on/off button is not lighting up unless pushed). I can hit the on/off and leave the torch running while cutting.... not good. I know there is something simple like a switch not toggled right. The setup before the hard drive died was working perfect.
If anyone could help me. I would really appreciate the help
Thanks
Kevin

2

General Mach Discussion / new computer set up

« on: October 25, 2016, 12:41:49 PM »

My computer crashed and went to set up the new computer and got it going with use of your website but hit a snag. I'm using HP computer with windows XP (the old one was too), MACH3 and Gecko G540 but the "A" stepper motor is not working and was working prior to the crash. I need to change the Mach3 to a plasma not mill.
The old computer was set up prior to me getting so I have little knowledge of how to get it changed (bought from Viper CNC which is out of business)  or get it working as a CNC plasma configuration if you can point me in the right direction to fix my little problem.
Thanks
Kevin