1
Forum suggestions and report forum problems. / Absolute coordinates in G2/G3 circular interpolation
« on: July 03, 2007, 12:24:27 PM »
Dear all,
My problem is the following:
It appears that when passing a circular interpolation in the format "G2 X Y I J", the interpolation center (I J) is always interpreted by mach3 as a relative coordinate and never as a an absolute coordinate. Even with the proper G90, X and Y are correctly interpreted as absolute coordinates while I and J are treated as relative coordinates.
What can be done to make Mach3 G-Code interpretation to fit with the norme?
Best regards,
Gaƫl
My problem is the following:
It appears that when passing a circular interpolation in the format "G2 X Y I J", the interpolation center (I J) is always interpreted by mach3 as a relative coordinate and never as a an absolute coordinate. Even with the proper G90, X and Y are correctly interpreted as absolute coordinates while I and J are treated as relative coordinates.
What can be done to make Mach3 G-Code interpretation to fit with the norme?
Best regards,
Gaƫl