Hello Guest it is March 28, 2024, 04:38:46 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Shelly

Pages: 1
1
General Mach Discussion / Mach3 problem , using High Z T1000 router
« on: October 25, 2023, 12:48:42 AM »
Hi I’m hoping you can help? I have just hooked up my High-z- T1000 to Mach3 . Its moves very well and carves 3d. All axis running in a spiral pattern . This moves x,y,z at the same time.
My problem is with the home and limit switchs on the original machine.( magnetic). Under diagnostics screen , each  switch  when triggered , is seen by Mach3 and the light toggles as it should, but mach 3 will not datum to zero, just runs paste the limit switch?can anyone help please?

2
Hi would appreciate if you have manage to solve your problem. I have been looking into changing my Chinese board problem and fitting a smooth stepper USB or Ethernet? How easy or tough is this to do , any wiring diagram set up would be much appreciated.

3
Hi, hopping someone has done this. I have a yoocnc parrellel port card on 6040 machine and want to wire this in to run  newforever inverter
Using Mach3. There are 3 pins on the board, but don' t know whether these are opts isolated ? The can be configured to apply 0-10v signal to the inverter. any advise appreciated.  :)

Pages: 1