Messages

1

General Mach Discussion / Re: Auto Z Probing retract height

« on: September 24, 2020, 12:01:38 PM »

mikec here now it moves .24 inch instead of 1inch when i zero it whats up with machine
help

2

General Mach Discussion / Re: Auto Z Probing retract height

« on: September 24, 2020, 10:46:05 AM »

thanks that worked but when  it touches plate it only retracts to 7/8 instead of 1inch is it the script
thanks mikec

3

General Mach Discussion / Re: Which wires in the control box should be shielded?

« on: September 24, 2020, 10:08:42 AM »

mikec here i fixed it mach3 general config go to de bounce it was at 0 i set it to 150 it stop tripping the limit switch
i must have alot of noise thanks for your help.

4

General Mach Discussion / Re: Which wires in the control box should be shielded?

« on: September 24, 2020, 09:52:31 AM »

Change the state of Probe pin (if Unchecked Active Low check it, and vice versa). i did no work  maybe i need to ground the chassis where BOB is 

5

General Mach Discussion / Re: Auto Z Probing retract height

« on: September 24, 2020, 09:30:19 AM »

hi mike c here hookup z touch probe (i watch a video from guru brew) but when i touch the ground lead to the spindle the limit switch trips
and the digitized button is on when i touch the probe ground to the plate it goes off
can you help thanks mikec

6

General Mach Discussion / Re: touch probe install on mack 3

« on: September 24, 2020, 09:28:30 AM »

hi mike c here hookup z touch probe (i watch a video from guru brew) but when i touch the ground lead to the spindle the limit switch trips
and the digitized button is on when i touch the probe ground to the plate it goes off
can you help thanks mikec

7

Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!

« on: November 01, 2017, 05:58:15 PM »

rocmen herei built a cnc router set it up when i reference all  my y axis has 2 motors they go the same way until l it hits the limit/home switch then the a axis go in reverse do i need a separate
home switch thanks for help rocmen

8

General Mach Discussion / Re: Mach3 not communicating with cnc machine....

« on: May 11, 2017, 08:03:27 PM »

hi i am new just built a cnc router was running fine till i switched from xp for win 7   i have no response on the mach3 screen
i changed ports and pins  no response on the screen 
can u help thsnk mikec