Messages

11

General Mach Discussion / Pin Test

« on: September 04, 2016, 11:57:56 PM »

Hi group, had a quick clarification.  I'm trying to set up my Mini CNC and was checking the voltage on my 25 pin port in back of my computer.  According to what I have read so far I should be able to read apx 5 volts when pressing the arrow keys.  I just tested my top row 1-13 right to left and all are reading 5+ volts without touching any arrows.  Any ideas?

A quick addition, my bottom row 14-25 left to right is reading pin 14-22 is reading 00 and pins 23-25 read 5+ volts with no arrows pressed.


Thanks Wayne

12

Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!

« on: September 04, 2016, 11:52:15 PM »

Hello all I'm Wayne.  I'm new to all this so I have a lot of questions.  But first, I'm Wayne I live in the SF BA for now and have recently purchased a Mini CNC Machine.  I had a project in mind that required the cnc router.  Now I'n working on getting eveything set up.  So I'm sure you'll be hearing from me now and then.