Guest
Show Posts
1
Show"N"Tell ( Your Machines) / Need Help!- DYNA MYTE DM4800C VMC MITSUBISHI MELDAS CONTROLLER
« on: August 31, 2016, 02:48:50 PM »
HALLO! I'm new here in the forum and i write this thread for find some help and info about a DYNA MYTE DM4800C MACHINING CENTER, these are the specifications:
X AXIS.......................: 32"
Y AXIS.......................: 20"
Z AXIS.......................: 20"
TABLE SIZE...................: 47.5" X 25"
MAXIMUM TABLE LOAD...........: 1,100 LBS
SPINDLE DRIVE................: 12 HP CONTINUOUS/ 15 HP 30 MINUTE
RATING
SPINDLE TAPER................: #40
TOOL CHANGER.................: 24 POSITION BI-DIRECTIONAL
RAPID TRAVERSE RATE..........: X, Y AND Z 472"/MINUTE
SPINDLE SPEEDS...............: 60 - 6,000 RPM
MACHINE WEIGHT...............: 11,440 LBS
The problem is that I don't have any manual about it and the machine is very old that I haven't found anything in Internet. Please, somebody help me D:
X AXIS.......................: 32"
Y AXIS.......................: 20"
Z AXIS.......................: 20"
TABLE SIZE...................: 47.5" X 25"
MAXIMUM TABLE LOAD...........: 1,100 LBS
SPINDLE DRIVE................: 12 HP CONTINUOUS/ 15 HP 30 MINUTE
RATING
SPINDLE TAPER................: #40
TOOL CHANGER.................: 24 POSITION BI-DIRECTIONAL
RAPID TRAVERSE RATE..........: X, Y AND Z 472"/MINUTE
SPINDLE SPEEDS...............: 60 - 6,000 RPM
MACHINE WEIGHT...............: 11,440 LBS
The problem is that I don't have any manual about it and the machine is very old that I haven't found anything in Internet. Please, somebody help me D: