Messages

1

General Mach Discussion / Re: Newbie with a question on Z axis

« on: August 24, 2016, 04:14:45 PM »

Thanks Hood.
Set the program up this evening and its working grand, as being a newbie I'll be learning by mistakes.
Again thanks
 

2

General Mach Discussion / Newbie with a question on Z axis

« on: August 22, 2016, 04:15:53 PM »

Just new to the mach3 software, my problem is when in the middle of a program and want to go back to zero the Z axis drags across the work piece. My question is? Is there a way of putting the Z axis into a safe mode or homing first before X & Y axis move.