Messages

51

Show"N"Tell ( Your Machines) / Re: MIKRON WF3 RETROFIT

« on: August 24, 2016, 05:36:16 AM »

the motor is a
http://callantechnology.com/callan_technology_products/TT-295X/TT-295X.html
kollmorgen/inland/callan TT2952B.
can i buy an alternativ controller for the servo motor?

i think, the BBC AMP only controll the speed and not the direction.

52

Show"N"Tell ( Your Machines) / Re: MIKRON WF3 RETROFIT

« on: August 24, 2016, 02:09:38 AM »

i have a question about the BBC servo amp.
mikron use a switch ( phase cange for motor and endcoder)  after the servo amp for + and -  feed.
but can i use the BBC servo axodyn 05LE  amp with +-10volt for + and - feed?
i connect the cs labs io to pin 3 (Vref+) and pin (Vref-).

53

Show"N"Tell ( Your Machines) / Re: MIKRON WF3 RETROFIT

« on: August 21, 2016, 07:22:03 AM »

1. Step

TNC 131  out and CS LABS with Heidenhain EXE602E and   frequency inverter in with the original servos.


2. Step

Modify Gearbox and ballscrew spindles

3. Step

DIY Tool Changer

4. Step

4.Axis

54

Show"N"Tell ( Your Machines) / Re: MIKRON WF3 RETROFIT

« on: August 21, 2016, 06:04:41 AM »

The big problem is the manual gear box.
I want to use a frequency converter and change only one gear with a belimo actuator......i hope it works.
any other idea?

for the linear scale i use a heidenhain EXE 602 e converter (sinus wave to ttl) box.

55

Show"N"Tell ( Your Machines) / Re: MIKRON WF3 RETROFIT

« on: August 21, 2016, 05:33:46 AM »

The work after 2 days

56

Show"N"Tell ( Your Machines) / MIKRON WF3 RETROFIT

« on: August 21, 2016, 05:32:35 AM »

My new Project
Mach 3 or 4, Mikron WF3, CS Labs Controller,
Backpack case for the original control panel
Touch screen