Messages

41

Show"N"Tell ( Your Machines) / Re: MIKRON WF3 RETROFIT

« on: September 08, 2016, 02:00:01 AM »

i want to connect the tool changer button for the hydraulic valve and collet chuck.

how is the right way for the option automatic tool changer and a faulty operartion at runtime M3/M4 spindle or  programm.

42

Show"N"Tell ( Your Machines) / Re: MIKRON WF3 RETROFIT

« on: September 06, 2016, 01:54:07 AM »

the "high-voltage" area is finished.

43

Show"N"Tell ( Your Machines) / Re: MIKRON WF3 RETROFIT

« on: August 31, 2016, 04:31:11 PM »

how should i connect the dahlander motor to the frequency converter?
low speed or highspeed?

can i turn/position the spindle for  ATC  with a dalander motor / frequency converter and  proximity sensor with a 6 tooth wheel?

44

CS-Lab / Re: CS- LABS CSMIO IP A and Kollmorgen S603 Servo Amplifier > Analog Mode?

« on: August 28, 2016, 11:54:53 AM »

i want to connect the linear scales to the csmio ip A, but need the amplifier (setting: analog input, torque mode? ) resolver feedback for propper working?
without the resolver cable is it easyer/cheaper

45

CS-Lab / CS- LABS CSMIO IP A and Kollmorgen S603 Servo Amplifier > Analog Mode?

« on: August 28, 2016, 06:10:43 AM »

Can i use the Kollmorgen S603 Servo Amplifier in the analog +-10V Mode without an Encoder?

46

Show"N"Tell ( Your Machines) / Re: MIKRON WF3 RETROFIT

« on: August 27, 2016, 09:06:38 AM »

2

47

Show"N"Tell ( Your Machines) / Re: MIKRON WF3 RETROFIT

« on: August 27, 2016, 09:00:06 AM »

new pictures

48

Show"N"Tell ( Your Machines) / Re: MIKRON WF3 RETROFIT

« on: August 26, 2016, 01:58:17 AM »

i mailed with callan yesterday..i need an amp  with 10A continus/ 90A? peak and115volt.
not easy to find and expensive with  tranformer.
i think, it ist better/cheaper to got the way with used AC servos/controllers

is it possibile to use a siemens servo (or any other with differnt encoders, because i use linear scales)  with a kollmorgen drive?

49

Show"N"Tell ( Your Machines) / Re: MIKRON WF3 RETROFIT

« on: August 24, 2016, 06:05:17 PM »

yes,  mikron use a relais for cw/ccw switch.
its a 2 quadrant motor....and i found only the callan controller with +-10 volt input.
http://www.callantechnology.com/callan_technology_products/product_range.html
but where can i buy it or similar???

50

Show"N"Tell ( Your Machines) / Re: MIKRON WF3 RETROFIT

« on: August 24, 2016, 04:35:27 PM »

after using google i found the follow motion controller with +-10v input:

Advanced Motion Controls Brush Type PWM Servo Amplifier 12A8K
or
Callan AS-80-8/15 DC SERVO AMPLIFIER