1
General Mach Discussion / Change direction of the work area
« on: August 16, 2016, 03:21:33 AM »
Hi. First post so please be gentle.
..and please excuse my bad english.
I can not find how to change direction of the work area?
When I run the machine to home pos, it goes to the lower right corner, which is correct.
But when I run a job I have to run to the upper left corner and put zero because the job would go toward + and not -.
Anybody know how to change this?
see attached image.
Many thanks
..and please excuse my bad english.
I can not find how to change direction of the work area?
When I run the machine to home pos, it goes to the lower right corner, which is correct.
But when I run a job I have to run to the upper left corner and put zero because the job would go toward + and not -.
Anybody know how to change this?
see attached image.
Many thanks