31
SmoothStepper USB / Re: USB Bandwith Problem & Solution
« on: October 14, 2009, 03:09:23 PM »
It is not quite clear what your problem was, but:
My SS (and mach together with it) froze quite quickly if I started my spindle, and the SS or the USB cable of the SS was near the frequency converter, or the (shielded) cable of te spindle... Seems to be noise issue to me...
I route the SS USB cable as far as possible from the spindle cables, and problem is gone...
My SS (and mach together with it) froze quite quickly if I started my spindle, and the SS or the USB cable of the SS was near the frequency converter, or the (shielded) cable of te spindle... Seems to be noise issue to me...
I route the SS USB cable as far as possible from the spindle cables, and problem is gone...